Disposal; Packaging; Removing The Battery - Silvercrest SHBS 500 B2 Bedienungsanleitung

BB*5$B%ERRN 6HLWH )UHLWDJ  2NWREHU    
5. Figure C: guide the lug of the shaving
head|10 under the edge of the hous-
ing and press the shaving head down-
wards onto the blades until it is heard
to lock in place.

8. Disposal

The symbol showing a wheelie
bin crossed through indicates
that the product requires sepa-
rate refuse collection in the Euro-
pean Union. This applies to the
product and all accessories
marked with this symbol. Products identified
with this symbol may not be discarded with nor-
mal household waste, but must be taken to a
collection point for recycling electric and elec-
tronic appliances. Recycling helps to reduce the
consumption of raw materials and protect the
environment.

Packaging

When disposing of the packaging, make
sure you comply with the environmental reg-
ulations applicable in your country.

Removing the battery

• This device is operated with a rechargea-
ble lithium-ion battery, which you must re-
move before disposing of the device.
• You must be technically minded to re-
move the battery, otherwise there is the
danger of injuring yourself. If you do
not have any experience with tools, you
should have the batteries removed by a
person who is qualified to do this.
DANGER from batteries!
~ Ensure that the battery is not damaged
as you remove it. Fire hazard!
~ The removed battery must not be disas-
sembled.
~ Never short-circuit the battery. The con-
tacts on the removed battery must not
be connected by metallic objects. The
battery may overheat and explode.
~ Only remove the battery to dispose of
the device. The device is destroyed by
removing the battery. Never try to oper-
ate a disassembled device.
1. Disconnect the device from the mains.
2. Switch on the device and let it run until
the battery is empty.
3. Figure B: remove the shaving
head|10 from the device (see "Clean-
ing and care" on page 8).
4. Figure D: use a Phillips screwdriver to
release the 3 screws on the back of the
device.
5. Use a screwdriver to lever open the
side seam and unfold the two halves of
the housing apart.
6. Figure E: use a Phillips screwdriver to
release the 3 screws in the plate and
fold it upward.
7. Figure F: release the connections be-
tween the battery and the board with a
pair of pliers/wire cutters. Remove the ex-
posed battery. Take the battery and the
device separately to suitable disposal.
The lithium-ion battery used
for this device may not be
treated as household waste.
The battery must be dis-
posed of properly. Contact
battery distributors or local
waste disposal points for
this.
Li-ions
GB 9