Assembling For Making Cookies - Gastroback Electronic Pro Bedienungsanleitung

Assembling for making Kebbe
1. Picture A: Take the worm housing into the right hand
and insert with your left hand the worm inside the worm
housing. The side of the worm with the plastic end has to face
the worm housing when putting it inside the worm housing.
If the worm is correctly assembled when the plastic end of
the worm pokes a few millimetres out of the worm housing.
2. Take the Kebbe attachment A. The flat end with the
recess has to face the worm housing when attaching. If
necessary turn the Kebbe attachment A a little bit until the
arresting pin of the worm housing locks precisely into the
corresponding recesses of the Kebbe attachment A.
IMPORTANT: If the tools overlap the edges of the worm housing the worm is not placed
all the way inside of the worm housing. Turn the worm a little bit to make it fit inside but do
not use force. If mounted correctly the Kebbe attachment A is flush with the front of the worm
housing and the axis of the worm pokes out 2 mm of the grinding disc.
3. Place the Kebbe attachment B on the worm housing and fit the
closure ring over the Kebbe attachment B (picture B). Firmly screw
the closing ring on the worm housing and tighten by hand.
ATTENTION: Do not use any tools, for tightening the screw and pay
attention not to cant the screw. If the screw cants the screw thread
gets damaged. If the screw does not turn easily put some sun-
flower oil (or other edible oil) on the screw.
4. Refer to ´Assembling for mincing` step 3 for further steps for assembling.

Assembling for making cookies

1. Picture C: Take the worm housing into the right hand
and insert with your left hand the worm inside the worm
housing. The side of the worm with the plastic end has to face
the worm housing when putting it inside the worm housing.
If the worm is correctly assembled when the plastic end of
the worm pokes a few millimetres out of the worm housing.
2. Take the adaptor disc. The small end with the recess
has to face the worm when attaching. If necessary turn the
adaptor disc a little bit until the arresting pin of the worm housing locks precisely into the
correspon-ding recesses of the adaptor disc.
IMPORTANT: If the tools overlap the edges of the worm housing the worm is not placed all the
way inside of the worm housing. Turn the worm a little bit to make it fit inside but do not use force.
If mounted correctly the adaptor disc is flush with the front of the worm
housing and the axis of the worm pokes out 2 mm of the grinding disc.
3. Place the cookie attachment on the worm housing. The flat end
has to face the worm housing when attaching. Fit the closure ring over
the cookie attachment (picture D). Firmly screw the closing ring on the
worm housing and tighten by hand.
A
C
30
B
D