Troubleshooting - JVC KD-X330BT Bedienungsanleitung

TROUBLESHOOTING

Symptom Remedy
Sound cannot be heard. • Adjust the volume to the optimum level.
• Check the cords and connections.
"MISWIRING CHECK Turn the power off, then check to be sure the terminals of
WIRING THEN PWR ON" the speaker wires are insulated properly. Turn the power
appears. on again.
"PROTECTING SEND Send the unit to the nearest service center.
SERVICE" appears.
Source cannot be selected. Check the [SRC SELECT] setting. ( 4)
• Radio reception is poor. Connect the antenna firmly.
• Static noise while
listening to the radio.
Playback order is not as The playback order is determined by the file name.
intended.
Elapsed playing time is This depends on the recording process earlier.
not correct.
"NOT SUPPORT" appears Check whether the file is a playable format. ( 19)
and file skips.
"READING" keeps flashing. • Do not use too many hierarchical levels and folders.
• Reattach the USB device.
"CANNOT PLAY" flashes • Check whether the connected device is compatible with this
and/or connected device
unit and ensure the files are in supported formats. ( 19)
cannot be detected.
• Reattach the device.
The iPod/iPhone does not • Check the connection between this unit and iPod/iPhone.
turn on or does not work. • Detach and reset the iPod/iPhone using hard reset.
Correct characters are not • This unit can only display uppercase letters, numbers, and
displayed. a limited number of symbols.
• Depending on the display language you have selected
( 4), some characters may not be displayed correctly.
Symptom Remedy
• Sound cannot be heard • Reconnect the Android device.
during playback. • If in [AUDIO MODE], launch any media player
• Sound output only from application on the Android device and start playback.
the Android device. • If in [AUDIO MODE], relaunch the current media player
application or use another media player application.
• Restart the Android device.
• If this does not solve the problem, the connected Android
device is unable to route the audio signal to unit. ( 20)
Cannot playback at • Make sure JVC MUSIC PLAY APP is installed on the
[AUTO MODE]. Android device. ( 7)
• Reconnect the Android device and select the appropriate
control mode. ( 8)
• If this does not solve the problem, the connected Android
device does not support [AUTO MODE]. ( 20)
"NO DEVICE" or "READING" • Switch off the developer options on the Android device.
keeps flashing. • Reconnect the Android device.
• If this does not solve the problem, the connected Android
device does not support [AUTO MODE]. ( 20)
Playback is intermittent or Turn off the power saving mode on the Android device.
sound skips.
"CANNOT PLAY" • Make sure Android device contains playable audio files.
• Reconnect the Android device.
• Restart the Android device.
21
ENGLISH