Bluetooth - JVC KD-X330BT Bedienungsanleitung

BLUETOOTH®
BLUETOOTH — Connection
Supported Bluetooth profiles
– Hands-Free Profile (HFP)
– Advanced Audio Distribution Profile (A2DP)
– Audio/Video Remote Control Profile (AVRCP)
– Serial Port Profile (SPP)
– Phonebook Access Profile (PBAP)
Supported Bluetooth codecs
– Sub Band Codec (SBC)
– Advanced Audio Coding (AAC)
Connect the microphone
Microphone
(supplied)
Microphone input jack
Secure using cord clamps
(not supplied) if necessary.
Pair and connect a Bluetooth device for the first time
1 Press
2 Search and select "JVC UNIT" on the Bluetooth device.
"BT PAIRING" flashes on the display.
• For some Bluetooth devices, you may need to enter the Personal Identification Number
(PIN) code immediately after searching.
3
Perform (A) or (B) depending on what scrolls on the display.
For some Bluetooth devices, pairing sequence may vary from the steps described below.
(A) "[Device Name]"
"XXXXXX" is a 6-digit passkey randomly generated during each pairing.
(B) "[Device Name]"
Rear panel
"PAIRING COMPLETED" appears when pairing is completed and " " will light up when the
Bluetooth connection is established.
Lights up to show the battery strength and signal strength.*
• This unit supports Secure Simple Pairing (SSP).
Adjust the microphone
• Up to 10 devices can be registered (paired) in total.
angle
• Once the pairing is completed, the Bluetooth device will remain registered in the unit even if
you reset the unit. To delete the paired device,
• A maximum of two Bluetooth phones and one Bluetooth audio device can be connected at
any time.
• Some Bluetooth devices may not automatically connect to the unit after pairing. Connect the
device to the unit manually.
• Refer to the instruction manual of the Bluetooth device for more information.
to turn on the unit.
"XXXXXX" "VOL – YES"
Ensure that the passkey which appears on the unit and Bluetooth device is the same.
Press the volume knob to confirm the passkey.
Operate the Bluetooth device to confirm the passkey.
"VOL – YES"
Press the volume knob to start pairing.
• If "PAIRING" "PIN 0000" scrolls on the display, enter the PIN code "0000" into the
Bluetooth device.
You can change to a desired PIN code before pairing. ( 13)
• If only "PAIRING" appears, operate the Bluetooth device to confirm pairing.
* Functionality depends on the type of the phone used.
"BACK – NO"
"BACK – NO"
13, [DELETE PAIR].
9
ENGLISH