Herunterladen Inhalt Inhalt Diese Seite drucken

JVC KD-X330BT Bedienungsanleitung Seite 26

Digital-media-receiver
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

TROUBLESHOOTING
Symptom
Remedy
No Bluetooth device is
• Search from the Bluetooth device again.
detected.
• Reset the unit. (  3)
Pairing cannot be made.
• Make sure you have entered the same PIN code to both
the unit and Bluetooth device.
• Delete pairing information from both the unit and the
Bluetooth device, then perform pairing again. (  9)
Echo or noise occurs.
• Adjust the microphone unit's position. (  9)
• Check the [ECHO CANCEL] setting. (  11)
Phone sound quality
• Reduce the distance between the unit and the Bluetooth
is poor.
device.
• Move the car to a place where you can get a better signal
reception.
Sound is being
• Reduce the distance between the unit and the Bluetooth
interrupted or skipped
audio player.
during playback of a
• Turn off, then turn on the unit and try to connect again.
Bluetooth audio player.
• Other Bluetooth devices might be trying to connect to
the unit.
The connected Bluetooth
• Check whether the connected Bluetooth audio player
audio player cannot be
supports Audio/Video Remote Control Profile (AVRCP).
controlled.
(Refer to the instructions of your audio player.)
• Disconnect and connect the Bluetooth player again.
22
Symptom
Remedy
"PAIRING FULL"
The number of registered devices has reached its limit.
Retry after deleting an unnecessary device. (  13, DELETE
PAIR)
"PLEASE WAIT"
The unit is preparing to use the Bluetooth function. If the
message does not disappear, turn off and turn on the unit,
then connect the device again.
"BT DEVICE NOT
The unit failed to search for the registered Bluetooth
FOUND"
devices during [AUTO CNNCT]. Turn on Bluetooth from
your device and connect manually. (  13)
"NOT SUPPORT"
The connected phone does not support Voice Recognition
feature.
"ERROR"
Try the operation again. If "ERROR" appears again, check if
the device supports the function you have tried.
"H/W ERROR"
Reset the unit and try the operation again. If "H/W ERROR"
appears again, consult your nearest service center.
If you still have troubles, reset the unit. ( 3)

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis

Fehlerbehebung

loading

Diese Anleitung auch für:

Kd-x33mbt

Inhaltsverzeichnis