Pioneer CT-S250 Bedienungsanleitung Seite 23

Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is something wrong with this component, check the
points below. Sometimes the trouble may lie in another component. Investigate the other components and electrical appliances being used. If
the trouble cannot be rectified even after exercising the checks listed below, ask your nearest PIONEER authorized service center or your dealer
to carry out repair work.
Symptom
Cassette door does not
e
open.
Cassette door does not • Cassette tape has not been loaded properly.
close.
No power when
• Disconnected power cord.
POWER switch is set to
a
ON.
Tape does not run.
•
•
•
•
No sound.
a
a
a
a
a
a
No recording.
a
a
a
a
a
Previous sound remains
a
when recording anew.
Low treble sound.
a
a
Boosted treble. a
Distorted sound. a
a
a
Unstable or intermittent a
sound. a
Cause
Tape mechanism was not stopped.
Power cord is connected to switched auxiliary outlet
on a stereo component which is not turned ON.
Tape is wound to its end.
Cassette tape not loaded properly.
Slack tape.
The deck is in the pause mode.
Stereo amplifier function switch is not set to TAPE,
Stereo amplifier volume control is at minimum
position.
Unrecorded tape has been loaded,
Improper stereo amplifier conne.ction.
Dirty tha haads.
Connection problems (wrong connection, cord
removed, poor contact, broken wire).
Cassette tape accidental erasure prevention tab
broken off.
Improper stereo amplifier connection,
Dirty tha haads.
REC LEVEL control set too low (no indication of the
level meter during recording),
Connection problems (wrong connection, cord
removed, poor contact, broken wire).
Dirty tha haads.
A tape which has not recorded with the Dolby NR
System is being played back with DOLBY NR on.
Dirty tha heads.
A tape which has recorded with Dolby NR System
is being played back with DOLBY NR off.
Distortion in recorded tape itself,
Recording level is too high,
Dirty tha heads.
Dirty heads, pinch roller and capstan.
Cassette tape is not wound up uniformly.
Remedy
a Press the stop (■) button,
a Load the tape again.
a Connect properly to a power outlet,
Turn on the power of that component.
a
Rewind the tape or turn tape over,
a
a Reload tape.
Take up slack using pencil (see pages 4 and 5).
a
Press the pause button.
a (II)
Set it to TAPE,
a
Turn up the volume.
a
a Use a recorded tape,
a Check all connections (see pages 7).
Clean the heads (see page 6).
a
Check to see if the Playback connection cord is
a
properly connected (see page 7),
Replace tape or cover tab hole with adhesive
a
tape (see pages 4 and 5).
a Check all connections (see page 7).
Clean the heads (see page 6).
a
Adjust the REC LEVEL control as indicated on
e
page 18 and record.
Check to see if the Recording connection cord is
e
properly connected (see page 7).
e Clean the heads (see page 6).
Set Dolby NR to off.
e
Clean the heads (see page 6).
e
Set DOLBY NR to B, C or S.
e
(DOLBY S type is CT-S450S only)
Try a different tape.
e
Turn down recording level and record again (see
a
page 18).
a Clean the heads (see page 6).
a Clean (see page 6).
e Fast forward or rewind tape to wind up tape again.
I
I
23
<RRE1135>
En