Removing The Shelf Holders - AEG S83200CMB2 Benutzerhandbuch

REMOVING THE SHELF HOLDERS

A
C
INSTALLATION OF THE CLEANAIR CONTROL FILTER
DOOR REVERSIBILITY
In case you want to change the opening
direction of the door, contact the nearest
B
Your appliance is equipped with shelf re-
tainers that make it possible to secure the
shelves during transportation.
To remove them proceed as follows:
1. Move the shelf holders in the direc-
tion of the arrow (A).
2. Raise the shelf from the rear and push
it forward until it is freed (B).
3. Remove the retainers (C).
The CleanAir Control filter is an active car-
bon filter which absorbs bad odours and
permits to maintain the best flavour and
aroma for all foodstuffs without risk of
odour cross contamination
On delivery the carbon filter is in a plastic
bag to maintain it's duration and charac-
teristics. The filter should be placed be-
hind the flap before the appliance is
turned on.
1. Open the flap cover.
2. Remove the filter from the plastic
bag.
3. Insert the filter in the slot found in the
back of the flap cover.
4. Close the flap cover.
The filter should be handled care-
fully so fragments do not loosen
from the surface. The filter should
change once every six months.
After Sales Service Force. The After Sales
Service specialist will carry out the reversi-
bility of the doors at your cost.
ENGLISH
21