Installation; Positioning; Electrical Connection; Removing The Shelf Holders - AEG SANTO C 8 16 41-4 i Benutzerinformation

Installation

WARNING!
Read the "Safety Information" carefully for your safety and correct operation of the ap-
pliance before installing the appliance.

Positioning

Install this appliance at a location where the ambient temperature corresponds to the
climate class indicated on the rating plate of the appliance:
Climate class
SN
N
ST
T

Electrical connection

Before plugging in, ensure that the voltage and frequency shown on the rating plate cor-
respond to your domestic power supply.
The appliance must be earthed. The power supply cable plug is provided with a contact for
this purpose. If the domestic power supply socket is not earthed, connect the appliance to
a separate earth in compliance with current regulations, consulting a qualified electrician.
The Manufacturer declines all responsibility if the above safety precautions are not ob-
served.
This appliance complies with the E.E.C. Directives.

Removing the shelf holders

Your appliance is equipped with shelf retainers that make it possible to secure the shelves
during transportation.
To remove them proceed as follows:
1. rise the shelf from the back (A)
2. push it in the direction of the arrow until
it is free (B)
3. remove the retainers.

Door reversibility

The door of the appliance opens to the right. If you want to open the door to the left, do
these steps before you install the appliance:
+10°C to + 32°C
+16°C to + 32°C
+16°C to + 38°C
+16°C to + 43°C
Ambient temperature
35
Installation
A
B