Removing The Shelf Holders; Door Reversibility; Environmental Concerns - AEG S83200CMB0 Benutzerinformation

Removing the shelf holders

Your appliance is equipped with shelf retainers
that make it possible to secure the shelves during
transportation.
To remove them proceed as follows:
1. Move the shelf holders in the direction of the
arrow (A).
2. Raise the shelf from the rear and push it for-
ward until it is freed (B).
3. Remove the retainers (C).
Installation of the CleanAir Control filter
The CleanAir Control filter is an active car-
bon filter which absorbs bad odours and per-
mits to maintain the best flavour and aroma
for all foodstuffs without risk of odour cross
contamination.
On delivery the carbon filter is in a plastic
bag to maintain it's duration and character-
istics. The filter should be placed behind the
flap before the appliance is turned on.
1. Open the flap cover.
2. Remove the filter from the plastic bag.
3. Insert the filter in the slot found in the
back of the flap cover.
4. Close the flap cover.
The filter should be handled carefully so fragments do not loosen from the surface. The fil-
ter should change once every six months.

Door reversibility

In case you want to change the opening direction of the door, contact the nearest After
Sales Service Force. The After Sales Service specialist will carry out the reversibility of the
doors at your cost.

ENVIRONMENTAL CONCERNS

The symbol
treated as household waste. Instead it should be taken to the appropriate collection point
on the product or on its packaging indicates that this product may not be
Environmental concerns
A
B
C
49