Closing The Door; Replacing The Lamp; Installation - AEG S83600CSW1 Benutzerhandbuch

40 www.aeg.com
Problem
The appliance does
not operate.
The lamp does not
work.
"dEMo" appears on
the display.
As much as the advice does not lead to result, call the nearest brand-mark service.

7.1 Closing the door

1.
Clean the door gaskets.
2. If necessary, adjust the door. Refer
to "Installation".
3. If necessary, replace the defective
door gaskets. Contact the Service
Center.

8. INSTALLATION

8.1 Positioning
Install this appliance at a location where
the ambient temperature corresponds to
the climate class indicated on the rating
plate of the appliance:
Possible cause
The appliance is switched
off.
The mains plug is not
connected to the mains
socket correctly.
The appliance has no
power. There is no volt-
age in the mains socket.
The lamp is in stand-by.
The appliance is in dem-
onstration mode.

7.2 Replacing the lamp

The appliance is equipped with a long-
life LED interior light.
Only service is allowed to replace the
lighting device. Contact your Service
Center .
Cli-
mate
class
SN
N
ST
T
Solution
Switch on the appliance.
Connect the mains plug to
the mains socket correctly.
Connect a different electri-
cal appliance to the mains
socket. Contact a qualified
electrician.
Close and open the door.
Keep pressed approxi-
mately 10 sec the OK but-
ton since a long sound of
buzzer is heard and the
display shut off for a short
while: appliance start
works regularly.
Ambient temperature
+10°C to + 32°C
+16°C to + 32°C
+16°C to + 38°C
+16°C to + 43°C