AEG S83600CSW1 Benutzerhandbuch Seite 39

Problem
Water flows on the
rear plate of the re-
frigerator.
Water flows into the
refrigerator.
Water flows on the
ground.
There is too much
frost and ice.
The temperature in
the appliance is too
high.
The temperature in
the refrigeration is
too high.
The temperature in
the freezer is too
high.
Possible cause
The product temperature
is too high.
The room temperature is
too high.
The FROSTMATIC func-
tion is switched on.
The COOLMATIC func-
tion is switched on.
During the automatic de-
frosting process, frost de-
frosts on the rear plate.
The water outlet is clog-
ged.
Products prevent that wa-
ter flows into the water
collector.
The melting water outlet
does not flow in the evap-
orative tray above the
compressor.
Products are not wrapped
properly.
The door is not closed
correctly.
The temperature in the
refrigerator is too low.
The door is not closed
correctly.
The product temperature
is too high.
Many products are stored
at the same time.
There is no cold air circu-
lation in the appliance.
Products are too near to
each other.
ENGLISH
Solution
Let the product tempera-
ture decrease to room
temperature before stor-
age.
Decrease the room tem-
perature.
Refer to "FROSTMATIC
function".
Refer to "COOLMATIC
function".
This is correct.
Clean the water outlet.
Make sure that products
do not touch the rear
plate.
Attach the melting water
outlet to the evaporative
tray.
Wrap the products better.
Refer to "Closing the
door".
Set a higher temperature.
Refer to "Closing the
door".
Let the product tempera-
ture decrease to room
temperature before stor-
age.
Store less products at the
same time.
Make sure that there is
cold air circulation in the
appliance.
Store products so that
there is cold air circulation.
39