What To Do If - Zanussi ZBB29450SA Benutzerhandbuch

3. Leave the
door open and
insert the
plastic scraper
in the appro-
priate seating
at the bottom
centre, placing
a basin under-
neath to collect the defrost water
In order to speed up the defrosting proc-
ess, place a pot of warm water in the
freezer compartment. In addition, remove
pieces of ice that break away before defrosting
is complete.
4. When defrosting is completed, dry the in-
terior thoroughly and keep the scraper for
future use.
5. Switch on the appliance.
6. After two or three hours, reload the previ-
ously removed food into the compartment.
Warning! Never use sharp metal tools to
scrape off frost from the evaporator as you
could damage it.

What to do if...

Warning! Before troubleshooting,
disconnect the mains plug from the mains
socket.
Only a qualified electrician or competent
person must do the troubleshooting that is not
in this manual.
Problem
The appliance does not
operate. The lamp does
not operate.
The lamp does not work.
www.zanussi.com
Possible cause
The appliance is switched off.
The mains plug is not connected to
the mains socket correctly.
The appliance has no power. There
is no voltage in the mains socket.
The lamp is in stand-by.
The lamp is defective.
Do not use a mechanical device or any artificial
means to speed up the thawing process other
than those recommended by the manufacturer.
A temperature rise of the frozen food packs,
during defrosting, may shorten their safe
storage life.
Periods of non-operation
When the appliance is not in use for long peri-
ods, take the following precautions:
• disconnect the appliance from electrici-
ty supply
• remove all food
• defrost (if foreseen) and clean the appliance
and all accessories
• leave the door/doors ajar to prevent unpleas-
ant smells.
If the cabinet will be kept on, ask somebody to
check it once in a while to prevent the food in-
side from spoiling in case of a power failure.
Important! There are some sounds during
normal use (compressor, refrigerant
circulation).
Switch on the appliance.
Connect the mains plug to the mains
socket correctly.
Connect a different electrical appli-
ance to the mains socket.
Contact a qualified electrician.
Close and open the door.
Refer to "Replacing the lamp".
Solution
21