Installation - Zanussi ZBB29450SA Benutzerhandbuch

Installation

Caution! Read the "Safety Information"
carefully for your safety and correct
operation of the appliance before installing the
appliance.
Positioning
Install this appliance at a location where the
ambient temperature corresponds to the cli-
mate class indicated on the rating plate of the
appliance:
Climate Ambient temperature
class
SN +10°C to + 32°C
N +16°C to + 32°C
ST +16°C to + 38°C
T +16°C to + 43°C
Electrical connection
Before plugging in, ensure that the voltage and
frequency shown on the rating plate corre-
spond to your domestic power supply.
The appliance must be earthed. The power
supply cable plug is provided with a contact for
this purpose. If the domestic power supply
socket is not earthed, connect the appliance to
a separate earth in compliance with current
regulations, consulting a qualified electrician.
The manufacturer declines all responsibility if
the above safety precautions are not observed.
This appliance complies with the E.E.C. Direc-
tives.
Door reversibility
The door of the appliance opens to the right. If
you want to open the door to the left, do these
steps before you install the appliance:
24
1
Loosen the upper
pin and remove the
spacer.
2
Remove the upper
pin and the upper
door.
4
Remove the lower
door.
4
Loosen the lower
pin.
Ventilation requirements
The airflow behind
the appliance must
be sufficient.
Installing the appliance
Caution! Make sure that the mains cable
can move freely.
Do the following steps:
3
Loosen the middle
hinge.
On the opposite side:
1
Install the lower
pin.
2
Install the lower
door.
3
Tighten the middle
hinge.
4
Install the upper
door.
5
Tighten the
spacer and the upper
pin.
5 cm
min. 200cm
min.
200cm
www.zanussi.com
2
2