What To Do If - Zanussi ZRG14801WA Benutzerinformation

3. defrost and clean the appliance and all ac-
cessories
4. leave the door/doors open to prevent un-
pleasant smells.

What to do if...

Warning! Before troubleshooting,
disconnect the mains plug from the mains
socket.
Only a qualified electrician or competent person
must do the troubleshooting that is not in this
manual.
Problem
The appliance is noisy
The appliance does not op-
erate. The lamp does not
operate.
The lamp does not work.
The compressor operates
continually.
Water flows on the rear
plate of the refrigerator.
Water flows into the refrig-
erator.
www.zanussi.com
Possible cause
The appliance is not supported
properly
The appliance is switched off.
The mains plug is not connected to
the mains socket correctly.
The appliance has no power. There
is no voltage in the mains socket.
The lamp is in stand-by.
The lamp is defective.
The temperature is not set correctly.
The door is not closed correctly.
The door has been opened too fre-
quently.
The product temperature is too
high.
The room temperature is too high.
During the automatic defrosting
process, frost defrosts on the rear
plate.
The water outlet is clogged.
Products prevent that water flows
into the water collector.
Important! If the cabinet will be kept on, ask
somebody to check it once in a while to prevent
the food inside from spoiling in case of a power
failure.
Important! There are some sounds during
normal use (compressor, refrigerant circulation).
Check if the appliance stands stable
(all the four feet should be on the
floor)
Switch on the appliance.
Connect the mains plug to the mains
socket correctly.
Connect a different electrical appli-
ance to the mains socket.
Contact a qualified electrician.
Close and open the door.
Refer to "Replacing the lamp".
Set a higher temperature.
Refer to "Closing the door".
Do not keep the door open longer
than necessary.
Let the product temperature de-
crease to room temperature before
storage.
Decrease the room temperature.
This is correct.
Clean the water outlet.
Make sure that products do not touch
the rear plate.
Solution
21