Herunterladen Inhalt Inhalt Diese Seite drucken

What To Do If - Zanussi ZRG714SW Benutzerinformation

Vorschau ausblenden Andere Handbücher für ZRG714SW:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

Important! Defrost the freezer when the frost layer reaches
a thickness of about 3-5 mm.
To remove the frost, do these steps:
1.
Switch off the appliance.
2.
Remove any stored food, wrap it in several layers of
newspaper and put it in a cool place.
3.
Leave the door open.
4.
When defrosting is completed, dry the interior thor-
oughly and refit the plug.
5.
Switch on the appliance.
6.
Set the temperature regulator to obtain the maximum
coldness and run the appliance for two or three
hours using this setting.
7.
Reload the previously removed food into the com-
partment.
Important! Never use sharp metal tools to scrape off frost
from the evaporator as you could damage it. Do not use a

What to do if...

Warning! Before troubleshooting, disconnect the
mains plug from the mains socket.
Only a qualified electrician or competent person must do
the troubleshooting that is not in this manual.
Problem
The appliance is noisy
The appliance does not operate.
The lamp does not operate.
The lamp does not work.
The compressor operates contin-
ually.
30
All manuals and user guides at all-guides.com
mechanical device or any artificial means to speed up the
thawing process other than those recommended by the
manufacturer. A temperature rise of the frozen food packs,
during defrosting, may shorten their safe storage life.
Periods of non-operation
When the appliance is not in use for long periods, take the
following precautions:
1.
2.
3.
4.
Important! If the cabinet will be kept on, ask somebody to
check it once in a while to prevent the food inside from
spoiling in case of a power failure.
Important! There are some sounds during normal use
(compressor, refrigerant circulation).
Possible cause
The appliance is not supported prop-
erly
The appliance is switched off.
The mains plug is not connected to the
mains socket correctly.
The appliance has no power. There is
no voltage in the mains socket.
The lamp is in stand-by.
The lamp is defective.
The temperature is not set correctly.
The door is not closed correctly.
The door has been opened too fre-
quently.
disconnect the appliance from electricity supply
remove all food
defrost and clean the appliance and all accessories
leave the door/doors open to prevent unpleasant
smells.
Solution
Check if the appliance stands stable (all
the four feet should be on the floor)
Switch on the appliance.
Connect the mains plug to the mains
socket correctly.
Connect a different electrical appliance
to the mains socket.
Contact a qualified electrician.
Close and open the door.
Refer to "Replacing the lamp".
Set a higher temperature.
Refer to "Closing the door".
Do not keep the door open longer than
necessary.

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis