Repairs; Troubleshooting - BOMANN DT 348 Bedienungsanleitung

A wrong or improperly performed repair brings danger to the user.
Repairs to electrical appliances must only be carried out by an authorized specialist. A damaged pow-
er cord must be changed only by a qualified electrician.
Before you contact an authorized specialist Before you contact an authorized specialist
Before you contact an authorized specialist Before you contact an authorized specialist
The following problems can be solved by you by checking for the possible cause.
Problem Problem Possible cause Possible cause
Problem Problem Possible cause Possible cause
The appliance is - Is the unit not connected to mains
not working power?
properly or at all. - Is the temperature setting correct?
- Is the place unqualified?
- Does the content prevent the appliance
door from closing properly?
- Are the ventilation openings clear of
obstruction?
The content is - Is the temperature setting correct?
not cold enough. - Was the appliance door open for an
extended period?
- Was large quantity of food placed in
the appliance within the last 24 hours?
- Is the appliance near a heat source?
Loud noise dur- Is the appliance not leveled vertically and
ing operation. horizontally?
Water on the - Is the temperature setting correct?
bottom. - Is the water discharge opening
blocked?
Interior light - Is the unit not connected to mains
does not work. power?
- Is the light bulb defect?
The housing The refrigeration cycle takes place in the foaming. The heat exchangers are installed in
becomes warm- the housing covered. The appliance cut the interior heat, which must be dissipated
ly. through the housing areas.
Water on the On days of high humidity, condensation might occur on the outer surface of the appli-
outer surface. ance. This is no malfunction; you may simply wipe the water off.

Repairs

Repairs
Repairs Repairs

Troubleshooting

Troubleshooting
Troubleshooting Troubleshooting
Solution Solution
Solution Solution
- Insert the plug properly in the contact
socket. Check the fuse.
- Check the temperature setting.
- Check the ambient temperature.
- Check the appliance content.
- Unblock the ventilation openings, install
the appliance freely.
- Check the temperature setting.
- Open the door only as long as necessary.
- Adjust a colder temperature.
- Check the installation location (see "In-
stallation").
Adjust the feet accordingly. Liquid flow
sounds in the cooling circuit are normal.
- Check the temperature setting.
- Check the discharge opening.
- Insert the plug properly in the contact
socket. Check the fuse.
- See the section "Interior light".
29