Repairs; What If - BOMANN VS 175 Gebrauchsanweisung

Pls. do as follows:
• Remove all food and keep covered at a cool location.
• Use warm water and a mild detergent for cleaning the interior (including rear side and bottom).
• After thorough drying, restart operation.
• Clean the condenser - metal grid on the rear side (if existing) once a year, using a soft brush or
vacuum cleaner.
WARNING
Do not bend the cooling coils.
Do not use arenaceous abrasives.
Changing the light bulb
WARNING
If the LED light bulb is damaged, DO NOT CHANGES IT BY THE USER!
Changing the light bulb carry out by inexperienced persons may cause injury or serious malfunction-
ing. It must be replaced by a qualified person in order to avoid a hazard. Contact your local Service
Force Center for help.
Before changing the light bulb, switch off the appliances
•
and unplug it, or pull the fuse or the circuit breaker.
Light bulb data: 220-240V
•
Unplug the mains plug.
•
Press the bulb in the center with finger.
•
Before changing the light bulb, either the refrigerator or disconnect the electricity leading into the re-
frigerator into the refrigerator at the main power supply. Failure to do so should result in electrical
shock or personal injury.
Remove the light cover out by one hand while pressing the middle of the light cover by force with
•
the other hand.
Replace with a 10 watt (or less than 10 watt) light bulb that is of the same shape and size.
•
Replace the light cover.
•

Repairs

WARNING
Servicing of electric devices must be conducted by qualified experts only. Incorrect or improper repairs
constitute a risk for the user and will void the warranty!
What if . . . Troubleshooting
The design of the device ensures a trouble-free operation as well as a long life cycle. Nevertheless, if
any defect occurs during operation, please check if it is caused by improper operation.
The following problems can be solved by you by checking for the possible cause.
PROBLEM POSSIBLE CAUSE
The device is Is the plug securely connected to the
not working mains? Has the safety mechanism of the
properly or at wall socket been triggered?
all Is the temperature control properly set?
Is the place unqualified?
Do food items or shelves and/or drawers
prevent the door from closing properly?
Is the ventilation of the device hedged?
Appliances Temperature is set too cold.
cools too
much
The food is Temperature is not properly adjusted.
too warm. Door was open for an extended period.
A large quantity of warm food was placed in
the appliances within the last 24 hours.
SOLUTION
Connect the plug properly to the socket,
turn on the fuse, and contact a technician if
necessary.
Check the settings.
Check the ambient temperature.
Arrange the food or shelves and/or drawers
properly.
Clear the ventilation slits, install the device
freely
Turn the temperature regulator to a warmer
setting temporarily.
Please refer to the "StartUp" section.
Open the door only as long as necessary.
Turn the control panel to a colder setting
temporially.
10
03/2012