Cleaning And Maintenance; Repairs - BOMANN DTE 236 Bedienungsanleitung

Haushalts- einbau- doppeltürkühlschrank

Vorschau ausblenden

Inhalt

Inhaltsverzeichnis

Verfügbare Sprachen

• Make sure that the temperature in the freezer does not rise above -18°C.

• The appliance should be defrosted regularly.

• Do not open the door longer than necessary.

• The door seal must be completely intact, so that the door closes properly.

WARNING:

• Always switch off the appliance and disconnect the plug or turn off / unscrew the fuse before cleaning and

user maintenance.

• Do not use steam cleaners for cleaning the appliance; moisture could enter electrical components. Risk of

electric shock! Hot steam could damage the plastic parts. The appliance must be dry before restarting op-

electric shock!

eration.

CAUTION

CAUTION: : : :

CAUTION

• Do not use a wire brush or other sharp, abrasive items.

• Do not use any acidic or abrasive detergents.

• Do not damage the refrigerant circuit.

C C C C lean the

lean the appliance including

appliance including interior regularly:

lean the

appliance including

• Remove the appliance content and storage at a cool location.

• Use warm water and a mild detergent for cleaning the appliance interior as well as the exterior.

• Clean the water discharge opening carefully with a pipe cleaner or knitting needle.

• Free the ventilation openings regularly of dust with a soft brush.

• After everything was thoroughly dried, you can restart the operation.

• We recommend an annual cleaning of the condenser (metal grid) on the appliance rear side. Dust can be

removed with a soft brush or a vacuum cleaner.

Interior light

Lamp specifications: 220- - - - 240 V

Lamp specifications: 220

• Remove the lamp cover.

• Replace the defect illuminant.

• Reattach the lamp cover.

• Reconnect the appliance and switch on.

A wrong or improperly performed repair brings danger to the user.

Repairs to electrical appliances must only be carried out by an authorized specialist. A damaged power cord

must be changed only by a qualified electrician.