Clean With A Soft Cloth/Kitchen - Pkm KF4-2KB N Bedienungsanleitung

still warm - but not hot!

3. Clean with a soft cloth/kitchen

paper and water, then dry carefully.
4. Connect the appliance to the mains
again.
Overcooked or melted food and stains caused by heated sugar-containing
Remove such
immediately with
ceramic scraper. Beware of cooking
zones which are still hot!
1. Disconnect the appliance from the
mains (fuse-box).
2. Hold the scraper in a 30
scrape off the contamination to a
cold area.
3. Clean the contaminated area with a
dish towel/kitchen paper.
4. Proceed as described in steps 2-4 in
the previous section.
1. Disconnect the appliance from the
mains (fuse-box).
2. Take away the contamination.
3. Wipe the sensors with a damp
sponge or cloth.
4. Dry the sensors with kitchen paper.
5. Connect the appliance to the mains
again.
Do not use any abrasive detergents! Do not use any organic detergents!
DANGER!
2
Detergents such as vinegar, citric acid etc.
food on the glass ceramic.
a contamination
a suitable glass
0
-angle and
Contamination of the control panel.
Do not use essential oils!
Replacing of the power cord
The power cord must be replaced by a qualified and
authorized professional only.
very careful.
Scourers,
abrasive detergents can scratch the
glass ceramic. Read the product
information of these detergents, so
you know if they are suitable to clean
glass ceramic.
Do not leave any residuals of a
detergent on the glass ceramic as it
can turn stained permanently.
Remove such contaminations as
soon as possible. When they cool
down on the glass ceramic, they are
difficult to remove and may damage
the glass ceramic permanently.
Be very careful when using the
scraper so that you do not cut
yourself (especially, when you have
removed the safety cover).
The appliance
automatically turn off. The sensors may
not work properly when they are wet.
Dry the control panel carefully before
you put it into operation again.
44
nylon-scourers
may beep
and
and
2