Danger To Life; Dmx-512 Connection / Connection Between Fixtures - EuroLite LED TMH-X25 Moving-Head Bedienungsanleitung

DANGER TO LIFE!

Before taking into operation for the first time, the installation has to be approved by an expert!
Screw one clamp via a M10 screw and self-locking nut onto the Omega-holder.
Insert the quick-lock fasteners of the first Omega-clamp into the respective holes on the bottom of the
device. Tighten the quick-lock fasteners fully clockwise. Install the second Omega-clamp.

DMX-512 connection / connection between fixtures

The wires must not come into contact with each other, otherwise
the fixtures will not work at all, or will not work properly.
Please note, the starting address depends upon which controller is being used.
Only use a DMX-cable and 3-pin or 5-pin XLR-plugs and connectors in order to connect the controller with
the fixture or one fixture with another.
Occupation of the XLR-connection:
If you are using controllers with this occupation, you can connect the DMX-output of the controller directly
with the DMX-input of the first fixture in the DMX-chain. If you wish to connect DMX-controllers with other
XLR-outputs, you need to use adapter-cables.
31/44 00092193.DOC, Version 1.1