Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Partial fixture hours
With this function, you can display the temporary running time of the device from the last power on.
Total LED hours
With this function, you can display the running time of the LED.
Partial LED hours
With this function, you can display the temporary running time of the LED from the last power on.
180° / display reverse
With this function, you can flip the display by 180° for a better view when the fixture is hung from the truss or
a ceiling.
Display language select
With this function, you can select the desired display language (English or Chinese).
DMX-controlled operation
You can control the projectors individually via your DMX-controller.
Every DMX-channel has a different occupation with different features. The individual channels and their
features are listed under DMX-protocol.
Addressing
The Control Board allows you to assign the DMX starting address, which is defined as the first channel from
which the LED TMH-X20 will respond to the controller.
If you set, for example, the address in the 18 channel mode to channel 19, the device will use the channel 19
to 36 for control.
Please, be sure that you don't have any overlapping channels in order to control each LED TMH-X20
correctly and independently from any other fixture on the DMX-chain. If several LED TMH-X20 are
addressed similarly, they will work synchronically.
Press the Up/Down-buttons for setting the desired starting address. Now you can start operating the LED
TMH-X20 via your lighting controller.
Note:
After switching on, the device will automatically detect whether DMX 512 data is received or not. If there is
data received at the DMX-input, the DMX indicator next to the display will blink. If there is no data received,
the DMX indicator will not lit.
This situation can occur if:
- the 3 PIN XLR plug (cable with DMX signal from controller) is not connected with the input of the device.
- the controller is switched off or defective, if the cable or connector is defective or the signal wires are swap
in the input connector.
34/40
00104631, Version 1.0
Werbung
Inhaltsverzeichnis
