Lipo Battery Charging; Ready To Start - Carson X4 Quadcopter 150 Betriebsanleitung

LIpo battery cHargIng

the quadcopter is fitted with a LiPo battery.
1. The supplied LiPo battery is stored in the body of the quad-
copter.
2. Connect the battery of the quadcopter to the connector of
the USB charger. The indicator light on the USB plug goes out
during the charging process. The light is glowing once charging
has finished.
Do not leave the copter or the charger unattended during the
charging process and always disconnect the battery from the
charger after completion! While charging, place the battery and
charger on a fireproof base!

reaDy to Start

Now we're good to go! But before liftoff, make sure that you have read this manual through completely.
1
Push the throttle lever fully down and then switch on the transmitter.
3
Now move the throttle lever completely up and then back down.
Now the quadcopter is ready to launch.
GB // 24
ON/OFF
2
Now connect the battery to the quadcopter.
The LEDs on the copter start to flash.