Speaker Connectors - Omnitronic E-Series Bedienungsanleitung

12
Input jacks
Inputs for channel 1 and 2 (optionally XLR, 6.3 mm
jack or RCA) for connecting units with line level.
13 Selector switch operating mode
position STEREO: stereo operation
position BRIDGE: bridge operation
14 Selector switch ground lift
position LIFT: signal ground and housing ground are
separated
position GND: signal ground and housing ground
are connected
15 Selector switch limiter
left position: limiter is switched off
right position: limiter is switched on
16

Speaker connectors

Speaker jacks for stereo operation.
17 Speaker connector
Speaker jack for mono operation.
18 Speaker connectors
Screw terminals for channel 1 and 2.
19 AC input with fuse holder
Used to plug the supplied power cord in. Only replace the
fuse when the device is disconnected from mains. Only
use fuses of the same rating and power. The correct fuse
value is specified on the rear panel.
24/31 00043864.DOC, Version 1.0