Danger To Life - Futurelight COLOR WAVE Bedienungsanleitung

be followed that this manual can only give in part. The operator must therefore inform himself on the current
safety instructions and consider them.
The manufacturer cannot be made liable for damages caused by incorrect installations or insufficient safety
precautions!
Install the safety bond by inserting the quick link in the attachment eyelet on the bottom of the base. Pull the
safety bond over the trussing system etc. Insert the end in the quick link and tighten the fixation screw.
The maximum drop distance must never exceed 20 cm.
A safety bond which already hold the strain of a crash or which is defective must not be used again.
Before taking into operation for the first time, the installation has to be approved by an expert!
(1) Omega-holder
(2) Clamp
(3) Safety-rope
(4) Quick-lock fastener
Screw the clamp via a M10 screw and nut onto the Omega-holder.
Insert the quick-lock fasteners of the Omega-holder into the respective holes on
the bottom of the device. Tighten the quick-lock fasteners fully clockwise.

DANGER TO LIFE!

2
4
The fixture's base enables to be mounted in two ways.
The Moving-Head can be placed directly on the stage
floor or rigged in any orientation on a truss without
altering its operation characteristics (see the drawing).
Make sure that the Omega-holder is always in line with
the truss structure when installing the device vertically.
For overhead use (mounting height >100 cm), always
install an appropriate safety bond.
You must only use safety bonds complying with DIN
56927, quick links complying with DIN 56927, shackles
complying with DIN EN 1677-1 and BGV C1 carbines.
The safety bonds, quick links, shackles and the
carbines must be sufficiently dimensioned and used
correctly in accordance with the latest industrial safety
regulations (e. g. BGV C1, BGI 810-3).
Please note: for overhead rigging in public or
industrial areas, a series of safety instructions have to
3
1
34/52 00081163.DOC, Version 1.0