PeakTech 2280 Bedienungsanleitung Seite 61

Note: You can also check the values of discharge time and capacity by pressing 【ENT】 during
the test.
Being in any other mode, press 【SHIFT】,【BAT】to enter the Battery Mode. Press then 【ON/OFF】
to start or to end the test. By restarting the test, the discharge time will be set to 0 again.
You should always set the parameters of the battery test first. Press 【SHIFT】,【BAT】 and 【ENT】
to set the parameters for discharge current and the cut-off voltage of the battery. See also 5.4.3.
-
61-