WolfVision VZ-8light 3 Bedienungsanleitung Seite 8

Shooting Area Outside of the Working Surface
Close-up adaptor lens
For shooting an object outside of the working surface, the close up lens (#5) has to be removed.
In this case just hinge the lens away from the camera head. It is impossible to remove the lens
completely from the unit and therefore can not get lost.
When using the Visualizer to again record on the working surface, put the close up lens back to
its original position.
Turning the camera arm downwards or upwards
In order to enable recordings with illumination outside of the working surface, the camera arm
and also the light of the Visualizer can be turned vertically.
Slide Drawer
Slide
∞
First make sure that you remove any object from the working
surface (very important!). Then insert a slide in the slide
drawer. The camera automatically recognizes the slide and
focuses on it.
In case the slide is out of focus:
- Make sure that the slide is firmly in place
- Make sure that the ZOOM is not in the maximum
tele position (=smallest picture).
Use the ZOOM-keys/wheel (#26 or #31).
Image Flip
By turning the camera head to record in
front of the Visualizer, the image will be
automatically turned 180 degrees
("image flip"). This feature is very useful
for recording the face of the presenter or
objects hanging on the wall behind the
unit.
7
up to 45mm
distance from
close-up lens
to the object
VZ-8plus³ only