Working Surface - WolfVision VZ-8light 3 Bedienungsanleitung

Setting Up the Visualizer
Power-on preset:
The power-on preset is automatically activated when switching on the unit.
The settings are: zoom size: approx. 20 x 15 cm (DIN A5), autofocus: on, auto iris: on.

Working Surface

The working surface of the Visualizer (#10) has a special crystalline white color, which is
especially designed for perfect reproduction of transparencies.
In the following cases, an optional lightbox is recommended:
- If the transparency is very dark
- If the transparency is very wavy and causes reflections
- If the room light causes reflections on a transparency
External WolfVision Lightboxes (optional)
Connect the power cord of the WolfVision lightbox to the lightbox connector (#23) on the back
of the Visualizer. The LIGHT key (#25) of the Visualizer can now be used to switch between
the light of the Visualizer and the light of the WolfVision lightbox.
When using a lightbox with a separate power supply be sure that the light of the Visualizer is
switched off to prevent reflections.
Shooting Area on the Working Surface
1. Connect the power pack to the power-input (#22).
2. Connect your display device (projector, monitor, video
conferencing unit etc.) to the appropriate output of the
Visualizer (#16, #17, #18, #19 or #20).
IMPORTANT:
For choosing the right output please read the
detailed description on page 11!
3. Pull the arm upwards by using the pull pad (#6).
4. Turn the camera head to working position.
5. Switch on the Visualizer with the power key.
Eliminating reflections
In order to eliminate reflections (on high gloss photographs etc.) just
move the recorded object or document and rotate the camera head to
center the desired pick-up area.
It is also possible to turn the camera arm with the light up or down
wards and rotate the camera head to the center of the desired pick-up
area to eliminate reflections.
Please note that reflections can also be caused by general room
lighting conditions.
6