Operation - EuroLite D-4 Bedienungsanleitung

Connect your loads via the output-sockets. The maximum load per channel is 1,150 W (resistive) or 600 W
(inductive). Please note that the maximum current (depending on the power-cord and power-plug) must
never be exceeded.
Analog output
Connect further power packs via the 9-pin Sub-D socket. The occupation of the 9-pin Sub-D socket is as
follows:
1. Ground
2. Not connected
3. Channel 2
Additional outputs
Connect your footswitch via the Start/Stop socket or the Standby socket on the rearpanel. In this way you
can stop the program-run.
OVERVIEW OVER THE DIFFERENT MODES
Dimmer:
If the Dimmer-button is pushed, the 4 channels can be controlled manually via the channel-faders. The total
output level is adjusted via the master-fader.
Organ:
If the Dimmer-button is pushed, the light organ function is activated:
Bass = channel 1, mid-range = channel 2, treble = channel 3, inverted bass = channel 4.
Show:
If the Show-button is pushed, the controller switches in 30-second periods from automatic program-run to
light organ function. Please make sure that you have connected a sound-signal. Otherwise there will be no
output in the light organ mode.
P.Auto:
If the P.Auto-button is pushed, the controller runs through the programs one after the other. The program-
speed is either sound-controlled (Audio-button pushed) or speed-controlled (Running Speed-control).
Audio:
If the Audio-button is pushed, the programs are run sound-controlled (Audio-LED lights up). If the Audio-LED
is off, the program-speed can be controlled via the Running Speed-control.

OPERATION

After you connected the device to the mains, the D-4 is ready for use.
Speed Control
When you switch off the sound control (AUDIO LED not lit), you can control the chaser speed with the
RUNNING SPEED-control.
Sound control
If you have connected the music source to the input on the rearpanel, you can activate the sound control by
pressing the AUDIO-button (AUDIO LED lit). The D-4 will chase to the bass-beat of the music. You can
adjust the sensitivity of the D-4 by turning the AUDIO LEVEL-control.
If you press the BEAT-button, all channels will be switched to the bass-beat of the music.
Program selection
- You can select the desired program (1-16) by pressing the PRG. UP/DOWN-buttons (all programs consist
of max. 64 steps)
- You can run through all programs by pressing the P.AUTO-button.
- Press the STOP-button in order to stop the program-run.
- B.OUT-button: all channels are switched off (the program continues running). If the controller is in the
blackout-mode, the Master LED is off.
4. Channel 4
5. Not connected
6. Not connected
13
7. Channel 1
8. Channel 3
9. Not connected