EuroLite D-4 Bedienungsanleitung Seite 12

Rearpanel:
CONNECTIONS
Sound input
Connect the sound-signal from the mixer (e.g. Master 2) with the ¼" mono jack on the rear panel (input
sensitivity 0.2 V - 1.5 V).
Connection with the mains
The electric connection must only be carried out by a qualified electrician!
In order to connect the device to the mains, you have to install a power-plug.
The occupation of the connection-cables is as follows:
Cable Pin
Brown Live
Blue Neutral
Yellow/Green Earth
The earth has to be connected!
Connect the device to the mains with the power-plug.
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
Outputs
Output is via 2 Bulgin-sockets and 4 Euro-type sockets (IEC) on the rearpanel.
The occupation of the 8-pin Bulgin-sockets is as follows:
Pin 1 Earth
Pin 2 Live channel 4
Pin 3 Live channel 3
Pin 4 Live channel 2
Pin 5 Live channel 1
Pin 6 Not connected
Pin 7,8 Neutral
DANGER TO LIFE!
International
L
N
6
7
Neutral
Channel 1
5
4
Channel 2
1
3
Channel 3
2
8
Channel 4
Earth
12