Inhaltsverzeichnis
Werbung
B+
REM
GND
FUSE
POWER
Fusible supplémentaire
Supplementary fuse
-
+
Battery
Batterie
CH 3,4
MAIN-IN AUX-IN SUBWOOFER
FULL RANGE
SUBWOOFER
DISP
VOL
FAD
SENS
120
DISC
L
POPS
90
STO
CLAS
60
JAZZ
VOCA
SEL
RCL
30
BGM
R
FLAT
Hz
SRC
SUB
60
Reliez le branchement de l'alimen-
tation en courant B+ (10) directement
au pôle plus de la batterie de bord.
Reliez le branchement de l'alimen-
tation en courant REM (11) à la sortie
de la commande de l'antenne.
56
CH 3,4
CH 1,2
+
CH3
-
+
CH4
-
+
CH1
-
+
CH2
-
-
-
+
BRIDGED
+
BRIDGED
SPEAKER
Antenna output
Sortie de la commande
control
de l'antenne
Autoradio
Car radio
REMOTE CONTROLLER
L
RESET
R
PROTECT POWER
LINE-OUT
HI
LOW
SUB ON
SUB.L
SUB.F
RADIO
AUX
M
1 2 3 4
M1
M2
M3
M4
150
400
1K
2.4K
6K
15K
L'amplificateur est mis en service par l'in-
termédiaire de cette entrée, lorsqu'une ten-
sion de +12 V est en présence. A l'heure
Operation
After connection is carried out and the cabling checked once more, the Car Amplifier
can be put into operation for the first time.
After checking, reconnect the negative
terminal of the battery.
Press the RESET button (7) on the Car
Amplifier.
Slide the operating mode switch CH 3,4
(1) to the correct position for the vehicle
configuration.
Switch the car radio on
Turn the volume of the car radio to
approx. 75% of maximum volume.
Now
adjust
the
volume
with
UP/DOWN button (24) on the operating
panel.
With this, the volume is set to minimum
and the equipment reset to the factory
settings.
FULL RANGE for normal operation SUB-
WOOFER for operation with subwoofer
to loudspeaker connections CH 3,4.
The green POWER LED (6) lights.The red
PROTECT LED (5) goes out after expiry
of the switch-on delay. Should the red
PROTECT LED (5) light continuously,
then a fault is present. The amplifier
must be switched off immediately. In
such a case, check all connections and
loudspeakers. If no fault can be estab-
lished through this, please consult a
specialist.
the
Pressing on the upper end increases the
volume; pressing on the lower end
reduces it. The VOL indicator (30) in the
operating panel display changes accord-
ingly. This setting achieves the greatest
possible signal/noise ratio and the best
audio quality.
Note that the maximum volume depends
on the power capability of the loud-
speakers and of the Car Amplifier.
Too-high a volume can lead to damage
both to the loudspeakers and to the Car
Amplifier.
Overload can easily be heard through
the resultant distortion.
41
Werbung
Inhaltsverzeichnis
