Free.dive.alarms - Talis IQ-1201 Benutzerhandbuch

FREE Dive Main, information includes (Fig. 94) -
> NDC Time (hr:min) with wave/clock/profile icon.
> Temperature with °F (or °C).
> EDT (min:sec) with wave/clock icon.
> Current Depth with FT (or M) icon.
> NiBG, if any after NORM or FREE dives.
• A (< 2 sec) - to access Dive ALT 1.
• L (press) - to activate the Backlight.
FREE Dive ALT 1 (CDT), information includes (Fig. 95) -
> Graphics CDT, and ON (or OFF) flashing.
> CD Time (min:sec), colon flashing and clock icon if ON and a CD in progress; OFF and 0:00, colon flashing if no time
remains. If OFF, the CD Time previously set will be displayed indicating that it is set and ready to Start.
• S (< 2 sec) to toggle ON/OFF (Start/Stop the countdown).
• A (< 2 sec) - to access Dive ALT 1.
• Revert to the Main after 10 seconds if A is not pressed.
• L (press) - to activate the Backlight.
FREE Dive ALT 2, information includes (Fig. 196) -
> Time of Day (hr:min) with Time (clock ) icon, and AWAY icon if Alternate is selected.
> Max Depth with MAX and FT (or M) icons.
• A (< 2 sec) to revert to the Main, or after 5 seconds if A is not pressed.
• L (press) - to activate the Backlight.
FREE DIVE ALARMS
The Dive alarms sound 3 short beeps (1 or 3 times) as an indication that an event is occurring and as a reminder to view the
display to identify an event.
As the Audible sounds, a graphic identifying the event will flash in place of NDC Time.
FREE Dive alarms are separate and unaffected by NORM/GAUG mode alarm settings, and the Alarms that occur in those modes
are separate and unaffected by FREE Dive alarms.
CDT Alarm
When the FREE CDT decreases to 0:00 (min:sec), 3 short beeps will sound 3 times during which the graphic CDT will flash (Fig.
97), then NDC will be restored.
Depth Alarms
When Depth reaches the Alarm 1 set point, 3 short beeps will sound 3 times during which the graphic DA1 will flash (Fig. 98),
then NDC will be restored.
The audible and flashing graphic will be repeated when Depth reaches the DA 2 and DA 3 set points, if set ON.
If Ascent is made above a Depth Alarm value and then a descent is made below it, the respective Alarm (DA) will reset and
sound again.
EDT Alarm
The EDT Alarm is factory set to repeat every 30 seconds when it is set ON prior to the dive.
When the EDT Alarm is set ON, 3 short beeps will sound during which the graphic EDT will flash (Fig. 99), then NDC will be
restored.
©2002 Design, 2014
--------------------------------------------------------------------------------------------------------
41
TALIS
OWNER'S MANUAL
Fig. 94 - FREE DIVE MAIN
Fig. 95 - FREE DIVE ALT 1
Fig. 96 - FREE ALT 2
Fig. 97 - CDT ALARM
Fig. 98 - DEPTH ALARM
Fig. 99 - EDT ALARM
Doc. No. 12-5355-r01 (1/20/14)