Remaining Risk Factors - Holzmann HBS245HQ Betriebsanleitung

The machine does not require extensive maintenance.
Repairing shall be performed by trained professionals only.
Accesories: Use only accesories recommended by HOLZMANN-Maschinen and its sales
partners.
12.3

Remaining risk factors

Even if the machine is used as required it is still impossible to eliminate certain residual risk
factors totally. The following hazards may arise in connection with the machine´s construction
and design:
 Damage to hearing, when sound levels in workshop add up to a total level being harmful.
Wear ear-muffs to eliminate this risk factor.
 Respiratory damages due to harmful emissions of wood dust.
 Severe cutting injuries at contact with the running band in the uncovered cutting zone.
 Injuries (cuts) when changing the band. Wear safety gloves when changing the saw band.
 Injury from catapulted workpieces or parts of workpieces.
 Injury through breaking saw band
 Electrocution through contact with internal leading machine parts
This risk factors can be minimized through obeying all security and operation instructions, proper
machine maintenance, proficient and appropriate operation by persons with technical knowledge
and experience.
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
 Never leave the machine running unattended! Before leaving the
working area switch the machine off and wait until the saw band
stops.
 Always disconnect the machine prior to any actions performed at
the machine.
 Avoid unintentional starting

 Each time you work with an electrically operated sawing apparatus,
caution is advised! There is a risk of electric shock, fire, cutting injury;
 Protect the machine from dampness (causing a short circuit)
 Use power tools and machines never in the vicinity of flammable
liquids and gases (danger of explosion)
 Check the cable regularly for damage
 Protect the cable from heat, oil and sharp edges
 Avoid body contact with earthed
 Use appropriate holding device when sawing logs
 The upper blade guide to keep as close to the workpiece
 Attach the fence to the lower half of the table for inclined table
 Workpieces while working safely hold and guide
 Remove the sawed-off or jammed workpieces only at standstill of the
saw blade
 Make sure that no excessive concentration of dust is produced. Use
suitable dust extraction equipment!
 Remove before editing foreign matter (nails, screws) from the
workpiece
 For straight cuts against the rip fence push stick should be used
HOLZBANDSÄGE / WOOD BANDSAW / SEGA PER LEGNO
SAFETY
37
HBS245HQ