Operation - Topcom orfeo 100 Bedienungsanleitung

Orfeo 100
3.2. SETTING THE SECURITY CODE
FOR REMOTE CONTROL
For remote control you first have to introduce a security code. The code is preset
to 123. However, we advise you to program a personal security code. The securi-
ty code must contain three digits. The symbols * and # are not accepted. You can
check the setting by pressing the Code button. The machine will say the set
security code. You can only hear the security code at the machine itself,
not during remote control.
Proceed as follows to change the security code:
1. Press the Code button 1,5 sec. until the machine says the first digit of the set
security code.
2. Press the Fast Forward button to select a higher digit or the Rewind button to
select a lower digit until you have reached the right digit. Each time you press
one of these buttons, the machine says which digit you have just selected.
3. Press the Code button to set the digit you have selected as the first digit of
your personal security code. Now the machine will say the second digit of the
security code to which it is set.
4. Press the Fast Forward button to select a higher digit or the Rewind button to
select a lower digit. Each time you press one of these buttons, the machine
says which digit you have just selected.
5. Press the Code button to set the digit you have selected as the second digit of
your personal security code. Now the machine will say the third digit of the
security code to which it is set.
6. Press the Fast Forward button to select a higher digit or the Rewind button to
select a lower digit. Each time you press one of these buttons, the machine
says which digit you have just selected.
7. Press the Code button to set the digit you have selected as the third digit of
your personal security code. The machine will repeat the security code you
have just set.
Remark : If during code setting no button is pressed for one minute, the
machine will automatically leave the setting mode and return to the
previous mode.
36

4. OPERATION

4.1. TWO ANSWERING MODES
You can register two outgoing messages: one for answering facility with
possibility to leave a message (outgoing message 1 = Announcement one) and
one for the answering facility without possibility to leave a message (outgoing
message 2 = Announcement two).
Use the On/Off button to select the desired answering mode:
A) Answering Facility With Possibility to Leave a Message
Hold down the On/Off button 1,5 sec. until the answering machine says :
"Announcement one on".
B) Answering Facility Without Possibility to Leave a Message
Hold down the On/Off button 1,5 sec. until the answering machine says :
"Announcement two on".
If no outgoing message was recorded, the machine will say : "Please record
announcement".
4.2. ANSWERING MACHINE ON/OFF
The Orfeo 100 can be put on and off by pushing the On/Off button.
When you switch on the answering machine and select the answering facility
with possibility to leave a message (point 4.1), the On/Off LED will light up and
you will hear "Answering one on".
When you switch off the answering machine, the On/Off LED will go out and you
will hear "Answer off".
37
Orfeo 100