Changing The Pin Code Of The Handset; Out Of Range Warning; Setting Speaker Volume Of The Handset; Setting Ringing Melody Handset - Topcom Butler 200 Bedienungsanleitung

R e m a r k :
This function does not allow you to have an intercom conversation between the base
station and the handset. Only a ringer sound can be activated.
8.15. CHANGING THE PIN-CODE OF THE HANDSET
By means of the PIN-code (Personal Identification Number) you can protect your hand-
set from the unauthorised changing of your settings. Standard this PIN-code has been
set to 0000. This can be changed as follows:
1 xxxx * #
(xxxx= current PIN-code)
- - - - - - - -
appears on the display.
Enter the new 4-digit PIN-code t w i c e and press the set button
P I N - c o d e .
Make sure that you do not forget the PIN-code of your handset.

8.16. OUT OF RANGE WARNING

Obstacles between the handset and the base station will influence the operation
range. When the handset is too far away from the base station, the quality of the con-
nection will deteriorate and you will hear a warning tone. The communication will be
broken automatically if you do not go back into the operation range within 10
s e c o n d s .
If a connection between the handset and the base station is not possible, you will
hear an intermittent warning tone.
8.17. SETTING SPEAKER VOLUME OF THE
HANDSET
The speaker volume of the handset can be set by pressing the buttons
(silent or loud)
18
to save this new
and

8.18. SETTING RINGING MELODY HANDSET

1 xxxx 1 2
Press 1 to select the ringing melody ( 8 types)
Press 2 to select the speed of the ringing melody ( 16 types).
Press

8.19. SETTING RINGING MELODY BASE STATION

Press the line button
2 xxxx 1 2
Press 1 to select the ringing melody ( 8 types)
Press 2 to select the speed of the ringing melody ( 16 types).
Press
Press the line button again.

9. TROUBLESHOOTING

SPEAKER OF THE HANDSET DOES NOT FUNCTION ANYMORE
(NO SPEAKER VOLUME)
• Check whether the delivered telephone plug has been used.
• Check if the telephone plug has been connected correctly.
THE DISPLAY DOES NOT FUNCTION
• Check if the battery connector has been connected correctly.
• Check if the battery charger contacts are not damaged or dirty.
• Charge the battery via the speed charge procedure as described in point 7.
Battery.
INDICATORS ON THE BASE STATION DO NOT FUNCTION
• Check if the adaptor and the telephone plug have been connected in the
19