Operation; Tone And Pulse Dialling; Making A Telephone Call - Topcom Butler 200 Bedienungsanleitung

· If you do not use your unit for a longer period of time, remove the battery from
the handset.
· If the battery in the handset has not been charged for a long period of time, charge
it following the speed charge procedure in "Charging of a new battery".
· Do not throw faulty batteries just anywhere, they are small chemical waste and
have to be treated as such.

8. OPERATION

With the following settings you will hear a confirmation signal each time the setting
has been executed correctly.
The settings are executed by pressing the buttons that correspond with the symbols
shown, f.i. = pushing the line button.
The indication XXXX shows that you have to enter your 4-digit PIN-code. Standard this
is set to 0000.

8.1. TONE AND PULSE DIALLING

Standard the Butler 200 has been set to tone dialling. If necessary, you can choose
pulse dialling.
8.1.1. TONE DIALLING
2 xxxx 10
During the tone dialling you can press the set button
prolong the tone signals (f.i. for the remote control of an answering machine). This
prolongation of the tone signals is cancelled when you push the line button.
8.1.2. PULSE DIALLING
2 xxxx 11
10
followed by the *-button to
8.1.3. TEMPORARY PULSE -> TONE SWITCH
You have the possibility to temporarily switch to tone dialling, for instance for tele-
banking, pager calls, remote control of answering machine, ...
You can use this function by pressing the *-button immediately after having dialed
the desired telephone number. The numbers that are now entered are sent in tone
dialling mode.
When you end the communication, the unit returns automatically to pulse dialling.

8.2. MAKING A TELEPHONE CALL

Make sure the correct dialling system has been set (pulse or tone dialling) as
described in 8.1. Tone and pulse dialling.
You can make a telephone call in 2 different ways:
1. Press the line button . When the radio connection has been established, you
hear a short beep.
The radio connection indicator on the base station lights and on the display of the
handset the radio connection symbol appears.
Now the desired telephone number can be dialed.
Press the line button to end the conversation.
2. You can also first enter the desired telephone number and press the line button
afterwards. This gives you the possibility to check the entered telephone number
before it is dialled (predialling feature).
In both cases the call timer appears 15 seconds after the last digit has been entered.
The call timer counts till maximum 99 minutes and 59 seconds.
If you wish to make another phone call, you can push the hang-up button
radio connection is not broken) and the following telephone number can be dialled.
11
( t h e