Entering 3 Or 4 Limits By Weighing; Numeric Entering Of 2 Limits - KERN pej Betriebsanleitung

12.5.2.

Entering 3 or 4 limits by weighing

To enter 3 or 4 limiting values [L1 SET] - [L3 SET] or [L4 SET], repeat steps 7 and
8 (see also chapter 12.4.2).
Display of tolerance mark
+ 



TOL


12.5.3.

Numeric entering of 2 limits

Operation
1. Activate tolerance weighing function
[2.SEL.2] or [2.SEL.3] (see chap. 7).
2. Actuate required parameter selection
or
until
.2] or [24.�TXP.2] appears;
[23.�P
1
more settings of your choice (see chap.
12.3) are carried out in the same way
3. Leave function menu
72
[L4.SET ] 4. limiting point
[L3.SET ] 3. limiting point
[R.SET ] Reference weight
[L2.SET ] 2. limiting point
[L1.SET ] 1. limiting point
Parameter selection for 2 limiting points:
Parameter selection for difference value:
The balance is now in tolerance weigh-
ing mode; the tolerance marker ( )
appears
Display
r�SEL�2
�
2q�CQ. � 1
�
2s�P . � 2
1 �
2t�TXP. � 2
a
z0
PES/PEJ-BA-e-1617
�
��
g