Tietzsch MultiSafe DSP HS5 Bedienungsanleitung Seite 15

11. Technical Data MultiSafe DSP HS5
Nominal voltage range:
Frequency range:
Input resistance:
Measurement current:
Surge voltage strength :
Indicator group:
Display:
Measurement range / limit deviation: 50 ... 1000 V DC ± 2,5% + 5 digits
On-time:
Construction:
Operating temperature:
Self-test:
Power supply:
Design:
Standards:
Test label:
Dimensions / weight:
50 ... 5000 V AC / 7000 V DC
0 ... 500 Hz
2,7 MΩ
2,6 mA at 7000 V DC
> 100 kV (VDE test report available)
I and III
red LED for voltage > 50 V AC / 120 V DC
green LED for standby / absent of voltage
two-line LCD with backlight white / red for indication of voltage,
frequency, type of voltage, and battery condition
acoustic signal at > 50 V AC / 120 V DC
50 ... 1000 V AC ± 5% + 10 digits
1,01 ... 7,00 kV DC ± 2,5% + 5 digits
1,01 ... 5,00 kV AC ± 5% + 10 digits
15 min
auto-off when absent of voltage
only for indoor installations
–15° C ... + 55° C
function and protective resistors
obligatory before indication of measurement results
9 V block IEC 6LR61 / 6LF22 / 6LP3146 alkali-manganese
multi-stage battery indicator
two-pole voltage tester with firmly attached high-tension
test probes made of GRP with moulded resistor decades,
approx. 1,35 MΩ each probe impact resistant,
dust proof plastic casing with unbreakable display cover,
protection category IP 65
twin insulated PUR hose cable
EN/IEC 61243-2 high voltage tester
EN/IEC 60071 surge voltage strength
further applied standards:
EN/IEC 61010 and EN 50110-1 (VDE 0105-1)
(further details see risk analysis)
date of the next examination on the sticker
repeated inspection at least every 6 years
550 x 70 x 70 mm / 500 g
15