Conrad FHT8 Bedienungsanleitung Seite 54

• An acoustic signal is generated, and "A1" is displayed.
• The valve operating mechanism fully retracts the control
pin to facilitate mounting.
• Now "A2" is displayed.
c) Mounting the valve operating mechanism on the ra-
diator
• Manually turn the coupling nut to fasten the valve oper-
ating mechanism on the valve
("1" in the figure on the right
side). When using valves by
"Danfoss" mount one of the
adaptors enclosed on the
valve first. The figures on the
next page show the adaptors
that have to be used for each
valve. Additional
for other valves may be pur-
chased separately.
• Briefly press the (2) key on the
valve operating mechanism
once (see figure on the right
side).
• "A3" is displayed on the LC display of the valve operat-
ing mechanism, and the valve is closed.
• On the display, the antenna symbol flashes and "0%" is
displayed.
• Close the battery compartment.
Please note:
If you have purchased the valve operating mechanism
separately (e.g. to use a second valve operating mecha-
nism for one heating control), you have to set the num-
adaptors
54