Inserting The Batteries Into The "Fht8R" Heating Control - Conrad FHT8 Bedienungsanleitung

correct polarity.
• Do not leave the batteries lying around in the open; there
is a risk of them being swallowed by children or pets. If
swallowed, immediately contact a doctor.
• Leaking or damaged batteries/accumulators may cause
burning if they come into contact with the skin. For this
reason you should use suitable protective gloves when
handling batteries.
• Do not short-circuit batteries/accumulators, and do not
throw batteries/accumulators into a fire. There is a risk of
explosion!
• Do not disassemble batteries/accumulators!
• Do not recharge normal batteries. There is a risk of explo-
sion!
• In case of longer periods of non-use (e.g. during stor-
age) remove the inserted batteries/accumulators to avoid
damage by a leaking battery/accumulator.
5. Inserting the batteries into the
„FHT8R" heating control
• Slide down and remove the wall holder on the back of the
heating control.
• Slide down and remove the cover of the battery compart-
ment (in direction of the imprinted arrow on the cover).
• Insert two AA batteries; pay attention to the correct po-
larity. Look into the battery compartment for an illustra-
tion of the correct polarity.
We recommend to use high-quality alkaline batteries
only. Operation of the heating control using accumula-
tors or conventional zinc-carbon batteries is possible,
operating time and radio range of the heating control
will, however, be reduced.
47