Conrad FHT8 Bedienungsanleitung Seite 49

b) Mounting the wall holder
Proceed as follows to mount the wall holder:
• Remove the wall holder on the
back of the heating
control, slide it down for this.
• Place the wall holder vertically
against the wall
with the round side pointing up
(see picture).
• Mark the positions of the bores
through the two slotted holes.
• Depending on the type of wall drill
two 6 mm holes and insert suit-
able dowels.
When drilling the bores and tightening the screws make
sure not to damage any power lines or gas or water
pipes, etc.! Danger!
• Fix the wall holder using e.g. the enclosed screws.
Pay attention that the two recessed slotted holes for
the screws point in your direction.
• If not already done so, insert the batteries into the
heating control before you slide the heating control
on the wall holder.
• Sliding of the heating control on the wall holder is
now possible from the top.
49