ESCORT 3145A / 3146A
Continuity
A
(Ω/2-wire)
(1)
Not Applicable
Tabelle 25: <f1><r1> and <f2><r2> Response for R0 Command
6.5.3.2
R1 command
After executing R1 command, the meter will return the current readings in its
primary display.
For example, a returned character string "+110.234E+0" represents the primary
display reading is "+110.234" when the meter executes R1 command.
6.5.3.3
R2 command
After executing R2 command, the meter will return the current readings in its
secondary display.
For example, a returned character string "-03.0000E+0" representing the primary
display reading is "–3.0000" when the meter executes R2 command.
If the meter is operating under primary display mode, it will return a character
"@>".
6.5.3.4
RALL command
RALL command is a combination of R0, R1 and R2. The meter will return the
meter status, primary display readings, and secondary display readings in
sequence.
For information regarding R0, R1, and R2, please see Table 6-11 and Table 6-12.
6.5.3.5
RST command
RST command can reset the meter to its power up initialization status without
shutting down the line power. It is useful to refresh the meter in warm-start.
Recommend waiting 4 seconds to run the next command.
Cosinus Computermesstechnik GmbH • Tel. 089-665594-0 • www.cosinus.de
1
2
3
(1)
N/A
4
5
6
7
(2)
For Model-A only
120Ω
400Ω
1.2kΩ
4kΩ
12kΩ
40kΩ
120kΩ
400kΩ
1.2MΩ
4MΩ
12MΩ
40MΩ
120MΩ
300MΩ
Seite 6-75