Return Result; Instructions Of Command Sets; Key Commands; Tabelle 14: Rs-232 Return Prompts - COSINUS ESCORT 3145A Bedienungsanleitung

ESCORT 3145A / 3146A
Prompts
? >
# >
S >
@ >

Tabelle 14: RS-232 Return Prompts

6.4.7 Return result

After the meter executes a query command the return of the result will be
in the following format:
<RESULT> + <CR> <LF> + <PROMPT> + <CR><LF>
If RS-232 of the meter is under print-only mode, the meter will print out the
measured data when the measurement cycle is completed. The format of
printed data will be shown as one of the following:
1. <Measurement Data> + <CR> <LF>
for only primary display mode is enabled, or
2. <Measurement Data #1>, <Measurement Data #2> + <CR> <LF>
for both primary display and secondary display mode are enabled
6.5

Instructions of Command Sets

6.5.1 Key Commands

Command
K1
K2
K3
K4
K5
K6
K7
K8
Cosinus Computermesstechnik GmbH • Tel. 089-665594-0 • www.cosinus.de
Description
A parameter error is detected.
The local key is pressed.
The set up function is under executing.
No numeric reading is available.
Equivalent Keystroke on the front panel
Press Vdc key
Press Adc key
Press Vac key
Press Aac key
Press Ω key
Press Diode key
Press Hz key
Press AUTO key
Seite 6-65