System:version; System:error - COSINUS ESCORT 3145A Bedienungsanleitung

Seite 7-98
the meter to store the minimum and maximum readings
reading.
CALC:REC:MAX
Example :
CALC:REC:MIN
CALC:REC:MINMAX ; Set the meter to show current reading.
• READing Subsystem:
READ? [
[ ,@1] | ,@2 ]
Description : Return the display value of output buffer after the next triggered
measurement is complete. Use @1 to select the primary display, and @2
to select the secondary display.
Response : Numeric data transferred as ASCII byte in <NR3> format.
Example : READ? ; Return the value shown on the primary display. For example,
READ??
Description : Return both display values of output buffer after the next triggered
measurement is complete.
Response : Numeric data transferred as ASCII byte in <NR3>,<NR3> format.
Example : READ?? ; For example , might output : " +1.23456E+0,12.34566E+0 "
• SYSTem Subsystem : ( SCPI approved ).

SYSTem:VERSion?

Description : Return the firmware version of the meter.
Response : Return the following information : Firmware version and Model of the
meter ; Firmware version and Model of the GPIB card.
Example : *IDN? ; Return: 'v1.31,6 ; v1.1,08'represents the Model-A meter installed
with firmware version "v1.31" and the Model 08 GPIB card installed with
firmware "1.1".

SYSTem:ERRor?

Description : Return the next message from the system error queue.
Response : <string> format, Table 7-5 is a list of SCPI error message that might
occur during operation.
Cosinus Computermesstechnik GmbH • Tel. 089-665594-0 • www.cosinus.de
; Set the meter to maximum recording mode.
; Set the meter to minimum recording mode.
might output: " +12.3456E+0 "
ESCORT 3145A / 3146A
or to show current