S2 Command; Tabelle 16: Descriptions For S1 Command - COSINUS ESCORT 3145A Bedienungsanleitung

ESCORT 3145A / 3146A
Syntax
<x> is an optional parameter for specifying a reading rate. It is defined
If <x> parameter is not specified, the meter will remain on its current
Table 6-6 shows all available S1 command parameters and available
Example 1: "S104S" (<f>, <r> and <x> are all specified)
Example 2: "S142"
Example 3: "S17"

Tabelle 16: Descriptions for S1 Command

6.5.2.2

S2 command

Command
In S2 command, <f>, <r>, and <x> parameters are used to set up the
S2<f><r><x>
<f> for specifying Measurement functions, <r> for specifying ranges,
<f> is a necessary parameter for specifying the measurement
Because the secondary display can only display DC V, AC V, DC A, AC
<r> is an optional parameter for specifying measurement range. The
Cosinus Computermesstechnik GmbH • Tel. 089-665594-0 • www.cosinus.de
by a character "S", "M", or "F", in which "S" is for slow rate, "M"
for medium rate, and "F" for fast rate
reading rate without change.
combinations.
Set primary display of the meter to DC V 120V with manual range
and at slow reading rate.
(<x> is omitted)
Set primary display to DC A 120mA with manual range, and the
reading rate will not be affected.
(Both <r> and <x> are omitted)
Set primary display to frequency with auto ranging and the reading
rate will not be affected.
secondary display measurements:
and <x> for specifying reading rate.
functions. <f> parameter is defined by a numeric value from "0" to
"9" and character "A".
A, and Frequency (Hz) functions, therefore, the available
parameters are "0", "1", "4", "5" and "7".
parameter value can be from "0" to "7". If <r> parameter is omitted,
<x> parameter should be omitted, too. The meter is set to auto-
ranging and will stay at the current reading rate.
Description
Description
Seite 6-67