RC Logger RC EYE One S Bedienungsanleitung Seite 36

What to do if you experienced your first crash
An easy way to maintain the products perfect condition is through visually inspecting the "RC EYE One S"
even after an apparently just slight crash. One of the most common causes is a propeller where the tracking
is out of its alignment. The likely cause for this is a bent motor shaft. Even a slightly bent shaft may have
serious consequences if not rectified quickly.
You can either replace the complete motor, or, what works in almost all cases, use a pair of flat pliers and
carefully bend the main shaft back into position. Keep in mind; if you hit an object at high propeller rotation
speed, it is highly likely that a shaft is bent. This is normal and requires your immediate attention!
You can easily visually check if a propeller's tracking is out of alignment. Hover your RC EYE One S around
2 meters away from yourself at level with your eyes and observe that you can only "see" one straight
rotating line per propeller. If one of the propellers appears to be visible "twice" (two lines), the tracking must
be fixed immediately!
What happens if a tracking misalignment is not fixed? Well, obviously one motor will have to work much
harder, draws much more power and eventually gets hot and, even best efforts have been made during
product design to prevent most such cases, the flight controller may burn at some point later.
It is strongly suggested to always inspect for damage.
replacing the propellers
attention!
observe the rotating direction of the respective motor and the choice of the
corresponding propeller without fail. If these are incorrectly chosen, the model will
not be able to fly and will act in an erratic way when next started! Loss of guarantee/
warranty! The rotating direction is marked on the propellers ("l" or "r"). The mark
"l" or "r" points up. The propellers marked "l" must be installed on the motors that
turn leftwards (counter clockwise). The propellers marked "r" must be installed on the
motors that turn rightwards (clockwise).
If a propeller is damaged in a crash or other action, replace it immediately. This also applies if there are any
fine tears or grazing in the propeller. Due to the high speed, material parts could come loose if the propellers
are damaged and this could lead to damage to or endangerment of the environment.
1. To replace a propeller, pull the damaged propeller from the motor shaft and replace it with a new one.
The propellers must not be pushed completely onto the motor shaft. Keep about 0.5 mm distance from
the motor housing.
36