RC Logger RC EYE One S Bedienungsanleitung Seite 30

Before start flipping, it is required to test if all 4 motors are working perfectly. To do
so, push throttle to max while hovering. The copter should ascend straight upwards
without leaning to any direction and without turning in its rudder axis. If the copter does
not ascend straight upwards, change the motor (or only the propeller) where the copter
is leaning to while at full throttle. Perform this step repeatedly until the copter climbs
straight upwards. To prevent injury and property damage always re-perform this test
after a crash or after a part replacement.
Product warranty does not include replacement of parts, compensation for property
damage of any kind, compensation for personal injury or injury to others resulting from
any flight maneuver where recommended safety guidelines have not been followed by
the pilot. you, the pilot are responsible to inspect your unit for perfect condition and
flight readiness before you attempt any kind of flight, regardless whether acrobatic flight
maneuvers or casual flight.
It is strongly recommended that you perform a full visual inspection each time before
you attempt a flight and each time you have encountered a crash, regardless if minor or
major crash. observe the condition of each motor, its motor shaft, its wire connections
and its propeller position and propeller condition. always replace defective parts
immediately. If you are unsure about your products condition consult an experienced
rC pilot or contact customer support at contact@rclogger.com immediately. do not
attempt any further flight until you have confirmed your products condition to be fine
and fit for flight.
you have been warned and you have accepted the warnings prior to using the product.
Activating acrobatic flight mode
To enable the acrobatic mode press and hold the 'ACRO button' while in flight.
Performing flip or roll
While pressing and holding the left front button on TX ('ACRO button') acrobatic mode is activated in
SPORT and EXPERT flight mode only. Status LED flashes fast while acrobatic mode is activated. After
releasing 'ACRO button' acrobatic mode is disabled again. When acrobatic mode is active, user can select
flip direction by pushing the nick/roll stick to any max direction. Combined flips (Combined 'Nick' and 'Roll')
are not allowed.
30