Technical Data; Optional Accessories - Metz MECABLITZ 60 CT-4 Bedienungsanleitung

months. The battery must supply sufficient power to light up the flash-ready
light within one minute after the flashgun was switched on.

12. Technical Data

Guide numbers at ISO 100/21°:
In the metric system: 60 In the imperial system:
8 auto apertures at ISO 100/21°:
2 - 2,8 - 4 - 5,6 - 8 - 11 - 16 - 22
Flash durations:
• approx. 1/200 . . . 1/20.000 sec.
• in M mode approx. 1/200 sec. at full light output.
• in winder mode approx. 1/14000 sec.
• in motordrive mode approx. 1/5500 sec.
Coverage angle of sensor: approx. 25°
Colour temperature: approx.: ca. 5600 K
Film speed: ISO 25 to ISO 3200
Synchronisation: low-voltage thyristor ignition
Number of flashes:
160* . . .4500 .
800 in winder mode.
1200 in motordrive mode.
Recycling time:
5 Sek. (in M mode) . . . 0,25 Sek.
in winder mode approx. 0.4 sec.
in motordrive mode approx. 0.2 sec.
Swivelling ranges and locking positions of flash head:
upwards: 15° 30° 45°
48
197
* at full light output
60° 75° 90°
counter-clockwise 90° 180°
clockwise 90° 180°
Dimensions approx. in mm (wxhxd)
Flash unit 102 x 254 x 102
Generator 126 x 165 x 58
Weight:
Flash unit approx. 650 g
Generator with 60-38 battery approx. 1850 g
Table 1: Guide numbers at maximum light output (page 82)
Table 2: Chargers (page 83)
Table 3: Flash durations at the individual partial light output levels (page 83)
Included:
Flash unit, bracket, 60-38 battery, generator, connecting cable, charger,
synch cable 45-47, light reducing filter 45-44, operating instructions, SCA
300/3002 table.

13. Optional accessories

Malfunctions and damage caused to the mecablitz 60 CT-4 due to the
use of accessories from other manufacturers are not covered by our
guarantee!
• Adapter of the System SCA 300.
For flash operation with system cameras (see separate operating instruc-
tions). The SCA 300 A connecting cable is additionally required.
• Adapter of the System SCA 3002
For flash operation with system cameras with digital data transmission of
the SCA function. The SCA 3000 C connecting cable is additionally requi-
red.
• Bounce diffuser 60-33 (Order No: 000060334)
To soften heavy shadows with reflected light.