Dedicated Flash Functions; Preparing The Flash Unit For Use; Mounting The Flash Unit; Power Supply - Metz MECABLITZ 58 AF-2 Pentax Bedienungsanleitung

2 Dedicated flash functions

Dedicated flash functions are flash functions that have been specially adapted to
a given camera system. Depending on the type of camera, different flash func-
tions are supported.
• Flash-ready indication in camera viewfinder/camera display
• Exposure control indication in camera viewfinder with TTL
• Automatic flash sync speed control
• Flash bracketing „FB"
• Automatic flash / triggering control
• Contrast control
• Spot beam mode „SB"
• TTL flash mode
• P-TTL flash mode
• Automatic TTL-/P-TTL-fill-in flash control
• Manual flash exposure correction
• 1st or 2nd curtain synchronisation (REAR, 2nd curtain, SLOW2)
• High-speed flash mode P-TTL-HSS
• Automatic motor zoom control
• Automatic AF measuring beam control (multi-zone AF measuring beam)
• Automatic flash range indication
• Programmed flash mode
• Preflash function for reducing the red-eye effect
• Wireless P-TTL remote flash mode
• Wake-up function for the flash unit
• Firmware update via USB connector
112
It is impossible to describe all camera types and their individual dedica-
ted flash functions within the scope of these instructions. Therefore, plea-
se refer to the flash mode description in your camera's operating instruc-
tions to find out which functions are supported and which ones have to
be set manually on the camera.

3 Preparing the flash unit for use

3.1 Mounting the flash unit

Mounting the flash unit on the camera
Turn off the camera and flash before mounting or removing.
• Turn the knurled nut towards the flash unit housing as far as it will go.
The locking pin in the adapter shoe is now fully retracted into the case.
• Slide the flash unit foot completely into the camera accessory shoe.
• Turn the knurled nut towards the camera housing as far as it will go, clam-
ping the flash unit in place. If the camera does not have a locking hole, the
spring-loaded locking pin retracts into the adapter case so as not to damage
the surface.
Removing the flash unit from the camera
Turn off the camera and flash before mounting or dismounting.
• Turn the knurled nut towards the flash unit housing as far as it will go.
• Remove the flash unit from the camera's accessory shoe.

3.2 Power supply

Suitable batteries/rechargeable batteries
The flash unit can be operated with any of the following batteries:
• 4 NiCad batteries 1.2V, type IEC KR (size AA). They permit very fast recycling
times and are economical in use because they are rechargeable.
• 4 nickel-metal-hydride batteries 1.2V, type IEC HR6 (size AA). They have a
significantly higher capacity than NiCad batteries and are less harmful to the