Indicators; Normal Conditions; Abnormal Condition - Yamaha DPX-530 Bedienungsanleitung

15

Indicators

This projector has two indicators, each of which shows the operation condition of the projector.
Refer to Troubleshooting for additional indication signals.
STANDBY/ON button

◆ Normal conditions

POWER STATUS
Steady red Off
Steady green Blinking green
Steady green Steady green
Steady red Blinking green
◆ Abnormal conditions
POWER STATUS
Steady green
or
Blinking orange
Steady red
Steady red Blinking green
Steady green Blinking green/red
Steady red Blinking red
Steady red Steady red
Blinking Off
green/red
Blinking Steady or Blinking
green/red
*1: When LAMP MODE of the SETUP menu is set to CINEMA. When it is set to BRIGHT, this duration will be decreased.
*2: When LAMP MODE is set to BRIGHT, this duration will be decreased to 2000 hours.
34
POWER indicator
CONDITION
Stand-by.
Warming up period (about 1 minute).
The projector is ready.
Cooling down period (lasts under 2 minutes; normal when
shutting down).
CONDITION
Abnormal temperature
• The ventilation grilles are clogged with dust or dirt.
• The room temperature is high.
Abnormal when it occurs except while shutting down. The
protection circuit is working or the lamp is in an abnormal
condition.
Lamp operation time warning. (Total lamp operation time
*1
reached 3000 hours while the power was on.)
Lamp operation time warning. (Total lamp operation time
*1
reached 3000 hours while the power was off.)
Lamp operation time warning. (Total lamp operation time
*1, *2
reached 4000 hours while the power was off.)
The lamp cover isn't closed.
Abnormal.
STATUS indicator
The STANDBY/ON button cannot be used
until the STATUS indicator is steady green.
Do not unplug the projector until the
STATUS indicator is off.
• Clean the ventilation grilles.
• Relocate the projector to a cooler place.
• Remove any objects blocking the
ventilation grilles.
• Wait until the STATUS indicator goes out,
then press the STANDBY/ON button.
• If the above solution is not effective,
replace the lamp.
Replace the lamp.
Change with a new lamp if this problem
recurs.
Close the cover correctly.
Contact your dealer.
NOTE
SOLUTION