Yamaha DPX-530 Bedienungsanleitung Seite 26

2. SETUP menu
ITEM SETTING
KEYSTONE ±20
AUTO POWER ON / OFF
ON
AUTO POWER OFF / 5 – 60min
OFF
SPLASH ON / OFF
SCREEN
HIDE SCREEN BLUE / BLACK
COLOR
LAMP MODE BRIGHT
CINEMA
LOCATION FRONT / TABLE
REAR / TABLE
REAR / CEILING
FRONT / CEILING
3. INITIAL menu
ITEM SETTING
MENU POSITION 2 positions
PROGRESSIVE AUTO
MODE
VIDEO
COLOR SYSTEM 8 positions
ASPECT DEFAULT
NORMAL
SQUEEZE
ZOOM
THROUGH
LANGUAGE 10 languages
RESET ALL
EXECUTE
22
FUNCTION
Use to correct vertical keystone distortion.
When ON is selected, the lamp is automatically lit when the power cable is plugged in the
wall outlet.
The projector is in the stand-by mode when the lamp is off. Use the remote control to turn on
the lamp.
Use to set the time elapsed before the projector enters the stand-by mode when there is no
signal input from the source.
Select ON to display the splash screen when the power is turned on
Use to change the color of the screen that appears when no signal is received.
Select when using the projector in a bright environment.
Select to moderate the intensity of the lamp. The operating sound is reduced and the lamp
lifetime becomes longer.
Frequent switching of the lamp mode may damage the lamp.
Select when viewing images from the front with the projector installed on the floor.
Select when viewing images projected from behind of the screen with the projector installed
on the floor.
Select when viewing images projected from behind of the screen with the projector installed
on the ceiling.
Select when viewing images from the front with the projector installed on the ceiling.
FUNCTION
Use to change the position of the menu.
The film mode will be automatically activated when a film source signal is inputted.
The film mode will not be activated.
When AUTO is selected, the appropriate video format is automatically selected depending on
the input signal. If the image isn't displayed correctly, select the desired video format
manually.
The appropriate aspect ratio is automatically selected depending on the input signal. Select
DEFAULT for normal use.
Select to project images with an aspect ratio of 4:3 when the input signal is 4:3 image.
Select to project images with an aspect ratio of 16:9.
Select to enlarge and project images of CinemaScope size or Vista size.
Select to project images in their original size as input. Not available when the keystone
adjustment is applied.
Use to select the language used in the menus.
Use to reset the settings of the menu (excluding LANGUAGE) to the factory setting values.